(NMR) (B6Z) (NMR) Standard Vertical Cable Entry Electrical System Pricing subject to change without notice. Call 1-866-SEAWIDE 415 (SVW) Cable & Accessories Charger Output Extension Cable Use this 15’ cable when your standard charger cables don’t reach the bow, center or transom battery compartments. The cable features WAGO Wall-Nut quick connectors (UL listed), and fused (30 amp) positive and negative leads. (MIN) Part No. Description 1820089 MK-EC-15 Charger Output Extension Cable Part No. Description 401252 Cable Clamp 0.25” Natural Nylon, 25 each 403252 Cable Clamp 0.25” Stain/Cushion, 10 each 403372 Cable Clamp 3/8” Stain/Cushion, 10 each 403502 Cable Clamp 0.5” Stain/Cushion, 10 each 403752 Cable Clamp 0.75” Stain/Cushion, 10 each 403892 Cable Clamp 1” Stain/Cushion, 10 each 403902 Cable Clamp 1.25” Stain/Cushion, 10 each 404152 Cable Clamp 1.5” Stain/Cushion, 10 each 404202 Cable Clamp 2” Stain/Cushion, 10 each 404252 Cable Clamp 2.5” Stain/Cushion, 10 each 404302 Cable Clamp 3” Stain/Cushion, 10 each Part No. Description CG20PG Plastic F/Wire up to 13.5mm / 0.53”, Grey CG20PB Plastic F/Wire up to 13.5mm / 0.53”, Black CG20SB 316 S.S. F/Wire up to 13.5mm / 0.53”, Black CG20SW 316 S.S. F/Wire up to 13.5mm / 0.53”, White CG20SS 316 S.S. F/Wire up to 13.5mm / 0.53”, Polished S.S. CG30PG Plastic F/Wire up to 27.5mm / 1.08”, Grey CG30SB 316 S.S. F/Wire up to 27.5mm / 1.08”, Black CG30SS 316 S.S. F/Wire up to 27.5mm / 1.08”, Polished S.S. CGM17PG Plastic F/Multiple Wires up to 10.6mm / 0.5”, Grey CGM17PB Plastic F/Multiple Wires up to 10.6mm / 0.5”, Black CGM17SS 316 S.S. F/ Multiple Wires up to 10.6mm / 0.5”, Polished S.S. Part No. Description 1001BSS CableClam 0.68” 1001100BSS CableClam with Stainless Steel Dress Cap 0.68” 1002BSS CableClam 0.83” 1002100BSS CableClam with Stainless Steel Dress Cap 0.83” 1003BSS CableClam 1.40” 1003100BSS CableClam with Stainless Steel Dress Cap 1.40” 1007BSS Side Entry CableClam 1007100BSS Side Entry CableClam with Stainless Steel Dress Cap Part No. Description CG30PG2 Plastic Vertical Cable Seal F/Wire up to 13.5mm / 0.53”, Grey CG30PG2 Plastic Vertical Cable Seal F/Wire up to 27.5,, / 1.08”, Grey Part No. Description AQ10 Waterproof VHF Radio Case AQ20LR Waterproof VHF Radio Case, Medium BE855 Electrical Panel Back Enclosure, 8x5x5” EX474 Electrical Enclosure, Medium EX1074 Electrical Enclosure, Large RP Remote Panel, Phase 3 Chargers AQ Series Waterproof Radio Covers When the AQ Series waterproof cover is used for protection, hand-held radios can be taken anywhere without being damaged by water, dust or sand. Even total immersion will not harm the radio. These covers are certified waterproof to a depth of 33’. The case is made of super-tough, UV resistant TPU (thermoplastic polyurethane), which is engineered with enough flexibility to facilitate easy operation of knobs and keypads. Transparent design allows easy reading of digital displays. Sound is virtually unimpeded and RF transmission is unaffected. Part No. Description CS1 Connector Strip, 12 Pair, 16 Guage CS2 Connector Strip, 12 Pair, 14 Guage WPF1 Cable Gland, Waterproof, .91” Hole WPF2 Cable Gland, Waterproof, 1.14” Hole Connector Strips Molded nylon encases 6 or 12 pairs of connectors that use screw compression to secure wires without use of lugs – ideal for electronic installations. Brass barrels capture wires and are held in place with a stainless steel “finger” compressed by a screw. The screw does not make contact with the wires, protecting the copper strands from cuts and breakage. Same connector strip used in BX Series boxes. Part No. Description CCXR Deck/Bulkhead Fitting, Large CCXS Deck/Bulkhead Fitting, Medium CCXT Deck/Bulkhead Fitting, Small DX3 Thru-Deck Fitting, 1.65” Opening DX5 Thru-Deck Fitting, 2” Opening RA1 Thru-Dex Fitting, 90º Smalll RA2 Thru-Dex Fitting, 90º Medium Waterproof Fittings - Thru-Dex, DX and CCX Series All fittings are waterproof. Thru Dex series route cable at 90º through vertical and horizontal surfaces with a wall-hugging, low-profile design. CCX series and DX series are feed-thru fittings. CCX series come with pre-drilled holes vs. DX series, the installer drills holes in seal to accomodate cable(s). (A4V) Cable Clamps Made from nylon for maximum strength. Resistant to solvents, oils, acids and moisture. Absorb shock and vibration to reduce unwanted noise. The unique screw hole alignment feature speeds installation. Cable Clams Provides a waterproof pass-through for antenna cables without requiring removal of the factory installed connector. Retrofit Vertical Cable Entry Cable entry is 100% Watertight (IPX6 & IPX7) with UV resistant plastic and one universal rubber bung. Drill tubes included. Available in grey plastic. No need to re-run cables, simply install with the cable in place. These standard vertical cable entries are 100% Watertight (IPX6 & IPX7) with UV resistant plastic and one universal rubber bung. Drill tubes included. No need to remove connectors. (NMR) (SVW)
RkJQdWJsaXNoZXIy MTAyMzU3Ng==